Updated November 2026

To convert refrigerator to kegerator, you need to add a tap tower, a gas line from a CO2 tank, and a thermostat that keeps the fridge near 38°F. Once those three pieces are in place, you can pour draft beer at home from a standard keg. The work is mostly plumbing and a few holes through the door, and a secondhand fridge makes it a very affordable build.

Choose the Right Refrigerator

Start with a fridge that has enough interior height for a standard corny or Sankey keg, which is roughly 16 to 18 inches tall with its coupler. Single-door units and older top-freezer models are common flea market finds and work well. Avoid fridges that use a freezer compartment to cool the main section, since the cold air will not circulate evenly enough for a reliable keg temperature.

Shopping for one? See our guide: 5 Best Kits to Convert Mini Fridge to Kegerators (2026).

Install the Tap Tower and Shank

Drill a hole through the door at the height where your tap handle will sit, usually near the middle of the door panel. Thread the shank through from the outside, add the washer and nut on the inside, and attach the faucet. Keep the shank as short as practical, because longer runs of beer line warm up faster and can cause foaming. Many home builders also add a drip tray at the base of the tower.

Set Up Gas, Lines and Temperature Control

Connect your CO2 regulator to the tank, then run gas line into the fridge and onto the keg’s gas post. Set the regulator to around 10 to 12 PSI for a typical ale and adjust from there based on your beer style and line length. Use an external temperature controller with a probe placed on the keg or in the middle of the fridge, and set it to about 38°F. Pour a test glass and tune the gas pressure until the beer flows cleanly.

Checklist for the Build

  1. Refrigerator with enough internal height for your keg
  2. Faucet, shank, and tower or door-mounted tap assembly
  3. Beer line, gas line, and keg coupler (type matched to your keg)
  4. CO2 tank and two-gauge regulator
  5. External temperature controller with probe
  6. Drip tray and a few hose clamps

Common Mistakes

  • Skipping the external thermostat and relying on the fridge’s built-in dial, which rarely holds a steady temperature.
  • Using beer line that is too short or too long, causing either foam or sluggish pours.
  • Setting CO2 pressure too high before checking your line length and beer temperature.
  • Forgetting to clean the faucet and lines regularly, which leads to off flavors.

A dual-gauge CO2 regulator makes it easy to see tank pressure and serving pressure at a glance. View on Amazon

An external temperature controller with a remote probe lets you hold the fridge steady regardless of how often the door opens. View on Amazon

FAQ

Can any refrigerator be converted into a kegerator?

Most single-door refrigerators can be converted if they are tall enough for your keg and cool evenly. Check the internal height and avoid units that rely heavily on a freezer compartment.

What temperature should a kegerator run at?

Most draft beer is served at about 38°F. An external thermostat set to that temperature helps keep the beer stable.

Do I need a tower to convert a refrigerator to a kegerator?

A tower is not strictly required, since a door-mounted faucet also works. Towers do make the setup cleaner and let you add a second tap later.

Conclusion

To convert refrigerator to kegerator, pick a tall fridge, install the tap and shank, and set up gas with an external temperature controller. Take your time with the line lengths and pressure, and your home bar will pour clean draft beer. Always check local regulations and gas-handling guidance if you are unsure about any part of the setup.

Caleb Morgan

About Caleb Morgan

Caleb Morgan is part of our editorial team and reviews and edits our home brewing guides, checking product details against manufacturer specifications and owner feedback.